This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Simulating SPI on keil using ARM9

hi all I am working on the project related to friendly arm 2440 having a S3C2440A board
I wanted to simulate the SPI peripheral but system viewer neither the peripheral tab in menu shows any such entry..
Can anyone suggest any solution

Thanks for the help..

Parents

0 M Herarrah over 12 years ago in reply to roger roger

the card is FAT compatible

that is a big problem. try not to get a card that is ext2 or ntfs. they are more expensive and are not compatible in lots of things. like cameras and videos and fridges and things like that.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 M Herarrah over 12 years ago in reply to roger roger

the card is FAT compatible

that is a big problem. try not to get a card that is ext2 or ntfs. they are more expensive and are not compatible in lots of things. like cameras and videos and fridges and things like that.
Cancel
Vote up 0 Vote down

Cancel

Children

0 roger roger over 12 years ago in reply to M Herarrah

thanks sir

But if there are any solutions then they will be appreciated.

Thank you

Roger
Cancel
Vote up 0 Vote down

Cancel
0 roger roger over 12 years ago in reply to roger roger

Hello all

Well I have waited a lot almost a week for answers but I suppose all the geeky heads have gone
to take a rest..If someone has awaken..
Please help me..

Thanks

Roger
Cancel
Vote up 0 Vote down

Cancel