This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setting all 8 breakpoints

Hi everyone,

I am debugging an application on a STM32F4 in flash with a ULINK.
I read one of the features for the ULINK should be 8 breakpoints, but after the 6th breakpoint I get an error message.
Isn't it possible to use all 8 breakpoints?
Maybe can I use 8 breakpoints with another device?

Can you help me with this?

Warden

Parents

0 Westonsupermare Pier over 12 years ago in reply to Bob Boys

Thanks Bob

Parking routines in RAM should also permit breakpointing in a similar fashion to the flashing mechanism of the J-Link. Sure it might take a bit more effort to set up the test cases, but when encountering limitations it helps to get creative rather than whining.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Westonsupermare Pier over 12 years ago in reply to Bob Boys

Thanks Bob

Parking routines in RAM should also permit breakpointing in a similar fashion to the flashing mechanism of the J-Link. Sure it might take a bit more effort to set up the test cases, but when encountering limitations it helps to get creative rather than whining.
Cancel
Vote up 0 Vote down

Cancel

Children

No data