I am getting a problem while burning the code in LPC2148 interfacing with GLCD. Flash Magic is showing an error- failed to autobaud. I want to know if we can directly connect GPIO pins of LPC2148 to 8 pin data bus of 128*64 GLCD???? Please reply immediately or as soon as possible...... I have to summit my project within a week.
It is clear from your posts that you don't know what you are doing.
I will not waste any more of my time helping you.
a likely cause is inability to read. TWO attempts to post code without even taking the time to read how to do it.
Erik