Hi, I'm running the MCBSTM32E Measure Example located in Boards\Keil\MCBSTM32E. The app is running well. But if I want to trace it with my Ulink2 It says Trace: No snychronization.
How I have to configure the Trace windows right? On the Debug I have choosen SWJ checked Port: SW Max Clock: 1Mhz
On Trace: screenshot: s7.directupload.net/.../2dfmkdfs.jpg
I want to trace all exceptions, systick interrupts etc.
The project contains also a retarget file. I want to use the integrated serial viewer of the keil debugger (usart#2) because I dont want to use a serial terminal.
What I'm doing wrong? Do I have to modify something? Optimization level is set to 0
regards jonathan
I'm not inventing anything new. at start it shows Data overlfow , then after 5-10seconds it changes to HW buffer overrun.
Yes I noticed that information but If I check nothing (no trace informations) its the same.