Hi, I run my code on Simulator and got 10 full loop of code per second , but when I run it on real AduC845 I got only 6 full loop, Can you advice when could be a source of it? Is it possible that handling intterupt(s) can slow down ADuC?
Regards Slawek
The uVision simulator is just an instruction set simulator - it does not do (and does not claim to do) a real-time simulation!
When you simulate a low-performance part on a high-spec PC, it is quite likely that the simulation will run faster than "real life"
See: http://www.keil.com/support/man/docs/uv4/uv4_dg_debug.htm