Hello all,
I'm a newbie to 8051 programming. I want to use Atmel's FLIP to program an at89c51rd2 chip using the COM port.
According to the FLIP instructions, there needs to be a bootloader on the chip before programming will work.
How does one get the bootloader onto the chip? Are there any straightforward tutorials on this?
Also, does anyone recommend doing a USB connection rather than using the COM port? The USB schematic looks much simpler than the COM port.
Thanks much.
I believe Wiznet has on-chip debug: "
Triscend had it - though they are now long dead.
AFAIK, it's probably fair to say that SiLabs is the only current, main-stream 8051 that has it?
The parametric device database search indicates 215 devices of 8051 architecture with on-chip debug: http://www.keil.com/dd/search_parm.asp
Actel Core8051 - VHDL Core
Analog Devices - ADE...; ADuC...
Asix
CAST - VHDL Core
Cybernetic Micro Systems
Evatronix
Infineon - TLE78xx; XC8...
Mentor Graphics - VHDL Core
Nordic Semiconductor
Nuvoton
Ramtron
Silicon Laboratories
STMicroelectronics - uPSD
Teridian - but see: www.teridian.com/.../press-release-20100412.htm
Texas Instruments - cc24...
Triscend/Zylogic
Some of these, of course, are obsolete; eg Triscend, uPSD...