• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 20 subscribers
  • Views 762 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error message

tass nuke

hi I am using Keil MicroVision 4 studio to run an assembly program. I get this error message and really I have not figure out why .I am using LMS3811 for Target, This is the error message "lab5.s(6): error: A1163E: Unknown opcode START , expecting opcode or Macro"

0