Updated to 4.21 last night checked it still compiled the current project which it does however this morning I need to debug on the target like I have been forever but everytime its about to switch over to the debug enviroment (i.e after the download+verifiy) in the IDE boom "uVision Ide has stopped working":
Problem Event Name: BEX Application Name: Uv4.exe Application Version: 4.21.0.0 Application Timestamp: 4dfb62ad Fault Module Name: StackHash_4c4a Fault Module Version: 0.0.0.0 Fault Module Timestamp: 00000000 Exception Offset: 00000000 Exception Code: c0000005 Exception Data: 00000008 OS Version: 6.1.7601.2.1.0.256.1 Locale ID: 2057 Additional Information 1: 4c4a Additional Information 2: 4c4ad7529a34983b6293625c48169922 Additional Information 3: 4c4a Additional Information 4: 4c4ad7529a34983b6293625c48169922
It was working fine on 4.20. Windows 7 Ultimate 64Bit, 8Gb Ram
anyone got any ideas other than step back to 4.20?
Hi
In the meantime there is a patch available from the Keil support team, which will solve this issue.
Regards Raphael
Hi,
you can always roll back if you have a look at the
c:\keil\Backup.xxx
folder.
BR, /th.
Whilst my original problem was solved via a patch I now find I variables local and otherwise are garbbage when viewed in the watch window, I've reverted to 4.20 for now until the next release which I hope gets tested better.
I would strongly suggest if your project is working and you don't have time to debug the the IDE etc don't load 4.21.
I noticed the same weirdness. I reverted to 4.20. Hopefully they will sort out the issues that grossly broke debugging
Hi Dave,
have you send a report including a small test case to Keil support (support.intl@keil.com)? Otherwise it would be difficult to solve such a problem if it is not officially reported to Keil.
Thanks in advance!
Best regards, Alexander Zaech
I have Raised a support ticket for it, however I don't have time to spend hours creating an example project, my client is definitely not going to pay for it when going to the last release solves the problem(s).
a little chicken and egg but that's life.
> however I don't have time to spend hours creating an example project Sure, I understand that.
Please look to the messages from Keil Support and follow their recommendation. Maybe the problem is already solved...
A further patched install has resolved this problem too.
Thanks Alexander for your prompt help
thanks for your feedback! I'm glad it has resolved your problem.
@all: If you are facing similar issues with variables showing garbage in watch/locals window or showing incorrect values (but in memory window they are OK) please contact Keil Support (support.intl@keil.com). As always, a small example project which shows the problem is appreciated!
Best regards, Alexander Zaech Senior Support Engineer ARM Germany GmbH