Keil forum Debugging CC2540 on Keil?

State Not Answered
Locked Locked
Replies 5 replies
Subscribers 22 subscribers
Views 3172 views
Users 0 members are here

Options

Related

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Debugging CC2540 on Keil?

Peter From over 13 years ago

Hi,

By default the TI CC2540 is supported by IAR Embedded Workbench, aswell is the hardware debugger "CC debugger".

Is it possible to debug the CC2540 in uVision?. Either by using the CC debugger, SmartRF05EB or SmartRF04EB?

Thanks

Parents

0 erik malund over 13 years ago

IAR Embedded Workbench ... Is it possible to debug the CC2540 in uVision?.
I doubt very much you can debug anything with uVision that is not built by it.
On the other hand, if uVisions tools can build it, they can debug it.

Erik
Cancel
Vote up 0 Vote down

Cancel

Reply

0 erik malund over 13 years ago

IAR Embedded Workbench ... Is it possible to debug the CC2540 in uVision?.
I doubt very much you can debug anything with uVision that is not built by it.
On the other hand, if uVisions tools can build it, they can debug it.

Erik
Cancel
Vote up 0 Vote down

Cancel

Children

No data