Hello to all. I am working todays on some projects that need controlling a solenoid valve with a at91sam7x256. I want to know what extra hard I need. I meen the driver of the solenoid valve. Actually I know we shall not connect that 2 pieces directly, but how and why? Another question is that which port of that micro best suits such a hardware if we need high speed serial communication. Thanks in advance for your attention.
1-I must assemble a prototype, program uC for my use, and test my equipment. 2- Forget it. 3- Forget it, too.
"2- Forget it. 3- Forget it, too."
So you felt your original post to have been badly thought out, and instead of answering these two questions you prefer to dodge?
"1-I must assemble a prototype, program uC for my use, and test my equipment."
Why "must" you? What forces you to do this?
www.lmgtfy.com/
"2- Forget it."
OK - but why, then, did you mention it in the first place?
"3- Forget it, too"
Does anybody here actually understands what the OP is after? I'm lost.
Does the OP actually understand what (s)he is after??