Hallo everyone, I have problem with communication over serial port.
This is what I am having problem with:
I need to make communication with device which has usb on rs232 convertor and fifo memory.
I sent data to fifo memory in same time device read data from fifo memory.
When micro (in device) sees that memory is full, it change state of CTS signal. CTS signal stays in that state until memory is half full.
I have problem to write code in C that sends data to device but considering CTS.
I send data as char byte array, memory is 4K , speed is 38400
Does anyone have a clue how I can solve this mistery
Milan
but the OP's problem is that (s)he can't even do that!
"RX the data at 9600bps"
You have to receive the data at whatever speed the source sends it - the OP specifically stated 38400.!
"This post will be edited later with more information."
I don't really see that your post has anything to do with this thread?