This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Enable Bulk transfer for LPC2378

Dear All,

I have used the HID code available in Keil Library. I am able to transfer one one byte Using control transfer but Now as per requirements and Specifications I need to transmit data that is more than 64 bytes..need to enable Bulk transfer can somebody..post some precious and valued Suggestions for How to enable bulk tranfer for LPC2378.

Thanks And Reagrds
Hrishikesh A Choudhary.

Parents

0 John Sinclair over 14 years ago in reply to hrishikesh choudhary

Hello,

use the MSC example in your Keil installation so you don't need nothing on the host side (if the host is a PC!). Or use the CDC so you need only an *.inf File.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 John Sinclair over 14 years ago in reply to hrishikesh choudhary

Hello,

use the MSC example in your Keil installation so you don't need nothing on the host side (if the host is a PC!). Or use the CDC so you need only an *.inf File.
Cancel
Vote up 0 Vote down

Cancel

Children

No data