i am using an ARM7 LPC2129 microcontroller for a driver fatigue detection system based on grip sensors.Once the sensors are triggered, the location of the vehicle(from GPS) is sent to a control room through a GSM modem. i need to add a webcam to the system that can take a short clip and then transmit it through the GSM modem. Can anyone help me on how to integrate a webcam with the ARM7 LPC 2129 and program it to take a short clip for 30 seconds and then send it through the GSM modem as MMS. I am using a Wavecom Q2406 GSM modem
as i told u in my earlier posts , i am working with a project center where the expertise they have is with a simple GSM modem that sends an sms of the vehicle's position that is obtained frm d gps unit. do u mean to say that it is possible to use the Q2406 modem to itself take an mms clip and then transmit it as MMS?? if this can be done can u tell me how exactly to proceed? i'm downloading OPEN AT but can u help me the specific codes that i need to use to program the Q2406 to do the above mentioned functions???
Again, what does that actually mean?
What is a "project centre"?
What, exactly, do they do?
What is their contribution to this project?
What is your contribution to this project?
forum.sierrawireless.com/viewtopic.php
a project center is one place wer they offer u a set of titles which u can choose frm. I've taken up a project tat uses a grip sensor that is uded to detect driver fatigue. they execute the project for me in return for a particular amount as fees. I and my team are taught how d various modules are executed n so on...otherwise in this part it is safe to execute a project at any of these centers as u hav less work. they offer to use a ARM7 processor and a GSM modem to send the positional info, but i wanna improve that by adding tis mms functionality. as they dont hav d expertise 4 tis i'm jus tryin to get some help in tis mms part.
"help" means that the majority of the work is your own - so, what have you done so far?
What is it, specifically, that you need "help" with?