This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

"No JLink Device found"

I am trying to download blinky program in a EFM32(G880f128) microcontroller on a EFM32G880F128-H development board by using a U-Link me debugger and the uVision-4 environment. But It comes up with an error message "No JLink device found".

Any suggestions?

Parents

0 Thorsten de Buhr over 15 years ago in reply to Thorsten de Buhr

please do not forget to set the Flash driver to 'Cortex-M3 JLink', too.
Set it in the 'Utilities' Tab in Debug Options. Probably you must select the correct programming algorithm.

.
BR,
/th.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Thorsten de Buhr over 15 years ago in reply to Thorsten de Buhr

please do not forget to set the Flash driver to 'Cortex-M3 JLink', too.
Set it in the 'Utilities' Tab in Debug Options. Probably you must select the correct programming algorithm.

.
BR,
/th.
Cancel
Vote up 0 Vote down

Cancel

Children

No data