HI, Actually i am doing IAP PROGRAMMING FOR lpc 2468.I am displaying the menu using uart 2 to run,progarm the user code. whenever i reset my controller the menu gets diaplayed and always ask for a command whether to run, program. my question is ,if i have programmed user code at 0x10000 location ,the next time when i reset my controller how can my controller run the user code and when iwant to change my application code how can i go back to IAP MODE i.e. how can i switch between IAP and user application mode????
I am not aware of anything called "IAP mode". You can, while in user mode or privileged mode, use IAP functions by addressing their fixed location in on-chip ROM.