We use ARM7 MCU of LPC2368 series for the application. While programming the ARM7 MCU using Flash Magic Tool version 5.89.2405, we get the error as "Operation Failed.(failed to autobaud - Step1)".
We use 11.0592MHz oscillator to drive the Controller. While programming it does not shows the Com port to which the device has been connected when checked through the device manger of the control panel. While using Keil MicroVision3 IDE for downloading the program to controller, it works fine. But, for Flash Magic Tool, it shows autobaud error. We checked all other hardware connections, it was found to be correct.
Please suggest the suitable solution for this autobaud error problem. And also suggest the baudrate and Com port at which the controller is to be programmed using Flash Magic Tool
Regards, Saikiran R. Embedded Software Engineer LCS Controls Pvt Ltd, Chennai, India
You claim to be an embedded software engineer. How can you calmly come to work when you don't know what these elementary terms mean? Did you check in your user manual? Did you google them?
Tapeer.
u need to remember even software engineers can start at the bottum.
it was not long ago when yew said u were an engineer and new arm but did not even no the abi existed.
Always yo're freind.
Zeusti.
(building supercomputer software for your mum)