Hi all!
Just got my start kit and nRF24LE1 development board from Nordic. I am trying the example project "display_joystick_nrf24le1". I set up Keil to use nRFProbe Keil Driver, under both Utilities and Debug. The program compiles just fine and outputs the .hex file.
Tried to transfer the hex with nRFgo Studio, and it seemed to be working, but the board does now react at all. Then I tried with Keil, it asks what board to use and then says ***Error: Unable to initialize target.
When pressing the "load" button in Keil, the 7-segment lights up a "0", so the board is deffinately recognized, but it just wont flash the memory.
Any suggestions to this?
Thank you so much in advance!