This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Compiler Error C141

I am getting compiler error for below given function written to read the MAC (IEEE) address of TI CC2430

( error C141: syntax error near 'code' ... & ... error C141: syntax error near ')' )

 // // Keil workaround
#define __code   code;

//IEEE MAC address in flash memory
#define MAC_FLASH_ADDR (0x3FFFF-7)


uint8_t IEEE_MAC[8];

void ReadMAC(void)
{
  bspIState_t state;
  uint8_t fmaptmp;
  uint8_t i;
  uint8_t code *flash;
  BSP_ENTER_CRITICAL_SECTION(state);
  while (FCTL & BIT7); //wait for the flash controller to be ready
  fmaptmp = FMAP;
  FMAP = MAC_FLASH_ADDR >> 15;
  flash = (code uint8_t *)((MAC_FLASH_ADDR & 0xFFFF) | 0x8000);  Compiler Error 
  for(i=0; i<8; i++)
  {
    IEEE_MAC[i] = flash[7-i];
  }
  FMAP = fmaptmp;
  BSP_EXIT_CRITICAL_SECTION(state);
}

I am not sure where I am going wrong any help would be appreciated. Thanks in Advance

0