This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Change Port 6 C167 CR

Hi there,

I am working on Phytec minimodul c167 and i would like to change the Pins 6.0, 6.1, 6.2, 6.3, 6.4
from Chip select mode to general purpose I/O. I know they are configured by RP0H in CSSEL but how i can be able to change that, as it's said that it can't be changed via software.

I would appreciate greatly any help, thanks in advance

Parents

0 Tarex M over 14 years ago in reply to HansBernhard Broeker

Cheers, i read this sentence but still am not sure how to configure this port during reset ?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Tarex M over 14 years ago in reply to HansBernhard Broeker

Cheers, i read this sentence but still am not sure how to configure this port during reset ?
Cancel
Vote up 0 Vote down

Cancel

Children

0 Andy Neil over 14 years ago in reply to Tarex M

Read section 7.3, Alternate Port Functions in the User Manual...

Then look at the schematics of your board, and the documentation that describes how it has implemented its Chip-Select configuration...
Cancel
Vote up 0 Vote down

Cancel
0 Tarex M over 14 years ago in reply to Andy Neil

Thanks, cheers.
Cancel
Vote up 0 Vote down

Cancel