This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ulink-me, uVision and "firmware update failed"

I have a MCBSTM32 board with an ULINK-ME JTAG. Previously I used an evaluation version of MDK/µVision 4.01 and everything worked well. I installed the latest version (4.12), and when i tried download the code to the µC, µVision asked for firmware update. I clicked "yes", and after a few seconds µVision showed message "firmware update failed". I tried this several times after reconnecting the JTAG, but it's always fails. Is it possible to use the µVision 4.12 with my JTAG? Or where can i download the 4.01 version of µVision?

Parents
  • same problem with my Ulink-Me.

    I installed the software the first time and the 4.12 uVision asked me to update the Ulink-Me. I clicked on "Yes" and he aborted with a firmware update failure.

    Since this i get all the time i want to debug / programm "SWD Communication Failure".

    I got now a replacement, but here the same problem: "SWD Communication Failure".

    On a second PC i have no problems with the new Ulink-Me. Seems to be the firmware update crashed something in my operating system, too!

    By the way, i posted my problem in a german forum, too:
    www.mikrocontroller.net/.../184466

Reply
  • same problem with my Ulink-Me.

    I installed the software the first time and the 4.12 uVision asked me to update the Ulink-Me. I clicked on "Yes" and he aborted with a firmware update failure.

    Since this i get all the time i want to debug / programm "SWD Communication Failure".

    I got now a replacement, but here the same problem: "SWD Communication Failure".

    On a second PC i have no problems with the new Ulink-Me. Seems to be the firmware update crashed something in my operating system, too!

    By the way, i posted my problem in a german forum, too:
    www.mikrocontroller.net/.../184466

Children