Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
Hi,sir!
I run candemo from \keil\arm\boards\keil\mcbstm32\can\can.uv2, and select simulator mode, then run, I cannot see any information in can communication window,but the can_primer_2009sp.pdf said can message with id of 0x21 will be appear in the can communication window.
Anybody can give me advice? I am very interested in Can bus, and want to use it in my project.
Thanks!
I open the Can:communication and Can:controller windows, and the status bar on the bottom shows " Simulation" and t1: timer is changing ,but I cannot see any message in the CAN:Communication window.
Do I need to check those bits on CAN:Controller window?