This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

USB Host HID Class Example for LPC2468

Hello,

I am hoping to setup my LPC2468 to act as a USB Host and to work with the HID Class. I am wondering if anyone has suggestions on example code or reading material?

I have gotten Keil's USB HID Client working on my hardware, and have been looking through the Host Lite Mass Storage example provided by Keil/Nxp/OnChip.

Any suggestions would be greatly appreciated.

Thank you,
Eric

Parents

0 Tamir Michael over 15 years ago

Hello Eric,

I asked Keil support a while ago the very same question. They said that they have indeed plans to implement the host-side software, but did not say "it will happen within x months/releases".
The best thing to do, I think, is to use an external hardware to get the job done. See www.ftdichip.com/FTProducts.htm
www.ftdichip.com/FTProducts.htm
or www.8052.com/.../168057 etc.
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Tamir Michael over 15 years ago

Hello Eric,

I asked Keil support a while ago the very same question. They said that they have indeed plans to implement the host-side software, but did not say "it will happen within x months/releases".
The best thing to do, I think, is to use an external hardware to get the job done. See www.ftdichip.com/FTProducts.htm
www.ftdichip.com/FTProducts.htm
or www.8052.com/.../168057 etc.
Cancel
Vote up 0 Vote down

Cancel

Children

No data