Hi,
I try to simulate my application with µVision4 (V4.10) simulator tool.
I create a stimuli on a pin (PIO1_5) using fonction editor tool. I see correctly my signal on logic analyser when i run the application.
My problem : I place a breakpoint at begin of PIOINT1_IRQHandler interrupt handler but the simulator never break. The interrupt is activated by application code.
If i use this same code with debugger on target, th debugger stop correctly at the breakpoint.
Could you have an idea of reasons why interruts don't work with simulator tool ?
Thanks a lot. Nicolas.
Any questions relating to potential bugs should be sent directly to Keil support, since they may not monitor all information on this forum.
Thank's,
I've send my request to Keil support ;-)
Best regards.