This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Reading ADC in debug mode

Hello everybody,

I have a board MCB2130 (Microcontroller LPC2138). I connected a small sensor to the P0.27 (AIN0.0). The output of the sensor supposed to be (1-1000 mV). I would like to be able to see the output value of the sensor on my ADC simulation peripheral dialog in the target debugging mode. Now whenever I click on "Start/Stop Debug Session" and open the "A/D converter peripheral dialog" nothing is changed at all. Can anybody help please? Is it possible to see the change of the sensor output in the A/D peripheral dialogue in real time?

Regards
Isaac

0