This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No Algorithm found

Hi,

I'm using the evaluation board MCB2300 with the lpc2378. (eval. µV4)
When i want to program the device with the program builded out of ( i2cmst.uvproj )

I get the following error:

"C:\\Users\\carl\\Desktop\\lpc\\LPC23xx_24xxSampleSoftware.r6\\Keil\\I2C\\Obj\\i2cmst_debug.AXF"
No Algorithm found for: 40000000H - 40000C2BH

Can you help me to solve this problem

Thanks in advance Carl

Parents

0 carl declercq over 15 years ago in reply to Robert

Thanks for the reply Robert,

I tried to start the debug session, but i've got the same error.
Is there something i must set, or do before i start the debug session.

Thanks
Cancel
Vote up 0 Vote down

Cancel

Reply

0 carl declercq over 15 years ago in reply to Robert

Thanks for the reply Robert,

I tried to start the debug session, but i've got the same error.
Is there something i must set, or do before i start the debug session.

Thanks
Cancel
Vote up 0 Vote down

Cancel

Children

0 Robert over 15 years ago in reply to carl declercq

Make sure that you uncheck "Update Target before Debugging" under the Target Option – Utilities Tab.
Cancel
Vote up 0 Vote down

Cancel
0 carl declercq over 15 years ago in reply to Robert

Thanks Robert,

All things are running ok !
Cancel
Vote up 0 Vote down

Cancel