• State Not Answered
  • Locked Locked
  • Replies 0 replies
  • Subscribers 20 subscribers
  • Views 492 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to configure MIFARE 1k on EPKSC emulator

Stephane F

Hi all,

I work on NXP P5CD081 chip.
I use the EPKSC emulator, µVision3 v3.60.

I try to configure the EPKSC emulator from the µVision3 IDE to be able to retrieve, in the contactless mode, the good value of the SAK in the configuration Mifare 1k (B1):

- In the menu "Project/Options for Target 'ProjectName'/Device/", I selected "P5DC081 (1k MIFARE)"

- In the menu "Project/Options for Target 'ProjectName'/Debug/Settings of EPKSC Target/Processor config/Mifare", I selected also "Mifare 1k (B1)"

Even in that case, I retrieve the SAK value from the MIFARE 4K configuration B4 (which is 0x38) instead of the value for MIFARE 1K configuration B1 (which would be 0x28).

I don't know why.
Any idea?

Regards.

Stephane.

0