Please note: We are aware of an issue affecting replies on the Arm Community forums, which may not be loading as expected.
We apologize for any inconvenience and appreciate your patience while we investigate and work to resolve the issue.
Thank you for your understanding.
Evaluation Board: MCB2300 Microcontroller: LPC2388 IDE: uVision V4.03q
My Setup: ============
1. I interfaced a 2-Wire Serial EEPROM (2K) to LPC2388. 2. I am using I2C0 on this board. 3. Therefore, using Pins 0.27 for SDA and 0.28 for SCL and external pull up resistors have been connected. 4. A 2-line, 5X8 LCD is also interfaced to this board.
My Objective: ================
4. This is my first program on I2C and I am writing a very basic program. 5. I want to WRITE a character in EEPROM at a memory location. 6. Then, I want to READ that character and display it on the LCD.
Where I am: ================
7. I am able to WRITE to and READ from the EEPROM and display it on the LCD.
The Issue: =================
8. The problem is, the statements in the main() run continuously in an infinite loop. I do not have a loop at all in the main().
Thanks, RB
The problem is resolved after I added an infinite loop at the end.
Thanks !!!
Sounds like you didn't look at the "hello world" example.
Jon