This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Luminary LM3S5B91

I have problems to flash my program.
Small programs (~400Byte) works, but my current program (~12k) I cannot flash correctly.

I'm using Keil v4.11 and Ulink2. Erase complete and erase partly works. On programming I get the error 'Flash Timeout'. I'm using a quartz of 8MHz. JTAG Clock max is 500k. The Flash algorithm ist LM3SXX.

Ideas?

Parents

0 Mike Herberich over 15 years ago in reply to Steffen Rose

With an Eval-Version you are not able to create a *.FLM-File! This is the reason why you get the error-message
Cancel
Vote up 0 Vote down

Cancel

Reply

0 Mike Herberich over 15 years ago in reply to Steffen Rose

With an Eval-Version you are not able to create a *.FLM-File! This is the reason why you get the error-message
Cancel
Vote up 0 Vote down

Cancel

Children

0 Steffen Rose over 15 years ago in reply to Mike Herberich

Better would be a compile error...

Keil v4.12 solved the Flashing error.
Thanks to the TI and Keil support.
Cancel
Vote up 0 Vote down

Cancel