I would like to receive analog(current) values thru CN10/CN11 to the STM32F10C Eval board, process them and output the values to the putside world thru a modem.
I am looking the ADC example given in peripherals library.In the readme.txt, I could not understand the lines - Connect a variable power supply 0-3.3V to ADC Channel14 mapped on pin PC.04 (potentiometer RV1 on STM3210B-EVAL and STM3210E-EVAL boards)
Where are the positive and negative lines from the variable power supply connected in the board?
How can I use the on-board Potentiometer for this example?
Any help is much appreciated.
Thanks for your inputs.
Yes, the board is ST and I have gone through the manuals and data sheet.But I could not extract the actual hardware connection for running this example. In Keil installation folder, I do see similar examples as of ST peripherals library. This ADC example is in C:\Keil\ARM\Examples\ST\STM32F10xFWLib\Examples\ADC\ADC1_DMA.
Hence I thought,I could get help from Keil support.
They are not just "similar" - they are the same!
Keil are simply providing a verbatim copy of the ST Firmware Library - complete with all the examples.
The STM32 documentation page is here:
www.st.com/.../familiesdocs-110.html
The STM3210C-EVAL evaluation board schematics are here:
www.st.com/.../stm3210c-eval.zip
The schematics are prevented as a PDF document - you can just search for "RV1"...
Should, of course, be "...presented as a PDF document..."