hi :) i'm looking for help on how to program the counter to count the number of pulses on my stm32 board.. i've a rough idea about how to go about doing it, but not sure if it is correct.
enable the counter start the timer stops the timer disable the timer read counter
i'm using uvision 4, ulink2.
is the above the correct way of programming the counter? i would appreciate any help!! thanks so much!!
my.st.com/.../Flat.aspx
Hey Andrew, thanks for the link =)
I still need help regarding this, I would really appreciate it if someone can guide me through e-mail or MSN. My address is keldio@hotmail.com.
Thanks so much, have a good day!
If you want personal tuition - or "consultancy" - you should expect to pay for that!
I just need help on this counter issue... not a longterm issue :(
But people helping you on email will only help _you_.
People helping you on a web forum will potentially help a number of other people too, since not only you will be able to see the conversation.
In short - hardly anyone is interested in any one-on-one consultancy without fees being payed.
Normally, a hardware timer can be programed to do what you want to achieve. Why not read the user manual?
Sorry about before, I realized I was being selfish..
Thanks Tamir, I just read the user manual.. but I still do not know how to program the pulse counter into the specific pin I want. I would really appreciate any help given! :)