I,m interfacing LPC2148 to PC through USB in the process of ennumeration after i recive set address command i send null packet n set address but then not getting setup packet for dd of 18 byte again getting set address
when i add to numbers i am getting the wrong answer.
example; a = 200; b = 210; c = a + b;
c is not 411.
what is the fault?
pls,. anyone know the fault? i must go to next fault very quickly.
... that you have hijacked this thread with a totally unrelated question!
You need to start you own, new for your own question.
... and refrain from hijacking a thread, I have the answer
Erik
So 200+210 is not coming out at 411.
"what is the fault?"
Tempting to say that it comes down to the schooling.