Hi, i am working on LPC2148. i am facing a problem while burning the code. in my board i am having options for RST and P0.14 pins. with these two switches iam trying to burn the code. Please help me out. Keil MCB2140 schematic is taken as reference.
Thanks in Advance.
Regards,
Kiranmai G
"i dint get any response so i have created a new thread."
Incorrect. I responded to this thread way before you created your new thread. But you did not respond to my comment about you having supplied too little information.
Creating multiple threads is not the way to get help. You get help by making sure that you supply the information you are required to. And by responding with feedback if someone do post an answer to your thread.
ok. I wont repeat it again...