Hi:
I have a device with an 8051F410 which uses C2 protocol to connect. I am using a USB Debug adapter in the Silabs IDE with a full Keil Compiler (all of this new within the last month) I can connect, erase memory, look at the RAM, etc. but when I try to download the code, it all seems to work fine, but at the end gives me the flash initialization error and says that the download failed. Someone said that I must have fried the chip, so I went out and bought from SiLabs their F411 Voice recorder board. Again, I could connect, erase, and see ram with C2, but I can not download the code due to the same flash error message. The IDE can't seem to find the 411 VR board if I try to use JTAG.
Any ideas on how to fix this... what my mistake has been?
Thanks,
Wes
I did fix the problem, but still would like to know the cause of it
you did fix the problem, but we still would like to know how
Erik
Proto_Board + IDE V2.6 + WindowsXP is OK Proto_Board + IDE V4.1 + WindowsXP is NG Proto_Board + IDE V2.6 + Windows Vista is NG Proto_Board + IDE V4.1 + Windows Vista is NG
F410 DK(very old F410 chip) + Winodows XP & Vista works fine.
Problem is in
Part Number : C8051F410 Product Revision : FC502J 0930