The manual says that if p0.14 is low while reset is low, forces on-chip boot-loader to take over control of the part after reset. However, when I connect this pin to ground, while the user code is executing (Blinky), the program stops! When I connect it to the 3.3V pin on the motherboard, Blinky starts running again! And all this time reset is never low. Is this supposed to happen? It doesn't seem so according to the flowchart in the manual.
Thanks for your reply Per, The Blinky is the same as the example code given in Keil Examples, except I am only blinking pins 17-20 instead of 16-23.