inverter byte

That was the kind of thing you could do with a Triscend.

I guess a PSoC could?

For ARM, Actel now seem to have taken up from where Triscend left off...

That was the kind of thing you could do with a Triscend.

I guess a PSoC could?

For ARM, Actel now seem to have taken up from where Triscend left off...

Hi.

Only for simply "inverter routine" I have use Triscend ???

Best Regards

No, of course you don't have to - but, if you were using one, it'd be easy!

(except for the fact that Xilinx killed Triscend years ago).

just curious if anyone knows if it can be done with the uPsd (the cypress thingy)

Erik

uPSD was the ST thing (originally Waferscale) - now EoL.

"The Cypress Thing" is the PSoC - as noted above, I guess that it (or, rather, they) probably can...

;=(FUNCTION)=================================================================
;
; Name       : SwapByte
;
; Action     : Swap bit order within byte
;
; Parameters : UByte Src (R7)
;
; Result     : UByte (R7)
;
; Notes      : Src - Data byte to undergo 'swapping'
;
;=(END)======================================================================

?PR?_SwapByte?SwapByte Segment Code

  Rseg ?PR?_SwapByte?SwapByte

_SwapByte:

  MOV   A,R7        ;Transfer to 'bit addressable' register
  MOV   C,ACC.0     ;Take bits (low to high)
  MOV   B.7,C       ;Transfer to another 'bit addressible' register
  MOV   C,ACC.1     ;And store (high to low)
  MOV   B.6,C
  MOV   C,ACC.2
  MOV   B.5,C
  MOV   C,ACC.3
  MOV   B.4,C
  MOV   C,ACC.4
  MOV   B.3,C
  MOV   C,ACC.5
  MOV   B.2,C
  MOV   C,ACC.6
  MOV   B.1,C
  MOV   C,ACC.7
  MOV   B.0,C
  MOV   R7,B        ;Job done
  RET

That is basically the solution from the post from 18-May-2010 08:57 GMT but with the difference that you save one register by being able to use the accumulator.

"...with the difference that you save one register..."

Same principle, yes.

But I'd say it not so much saving a register as saving memory, since it uses none. It only uses the standard registers and B which are freely available to be used within a function.

Look at the code produced for the compiled C if you have doubts.

Also, for what it's worth, the assembler snippet would be inherently task-safe.

How about this?
Only 16 bytes, and 13 clycles.
both src. and des. store in acc.

mov c,acc.1
rlc a
mov acc.2,c
mov c,acc.3
rlc a
mov acc.4,c
mov c,acc.5
rlc a
mov acc.6,c
swap a

mov c,acc.1
rlc a
mov acc.2,c
mov c,acc.3
rlc a
mov acc.4,c
mov c,acc.5
rlc a
mov acc.6,c
swap a

A neat solution. I'm going to have to remember it - Or (more likely) save to file in my 'snippet' subdirectory.

Thanks.

especially when it comes to basic programming tasks like this which has been around since the dawn of computing!