Hi, I have a function in my code which has its content commented. So it does nothing. When a I remove this function the system no longer works (the LED was blinking and now is turned off).
Tapeer.
thank u for yo're kind words of kindness and support.
Always yo're freind.
Zeusti.
(the abi reader)
Let me guess - "abi" stands for "Abnormal Brain Inactive" ?
u have been reeding the wrong book!
i thoght u knew what it was. most arm programmers know it. abi is the application binary interface.
i have found the link for u
infocenter.arm.com/.../index.jsp
Well, the t function is not called. It is a dummy function actually. There is no error in the link. The .hex file is generated, but no functionality of the system works. Neither blinking LED, nor others like uart communication. I use RTC RAM to store some important data. But it should not interfere the system working at this point. When I simulate the code in Keil it works. However, when I load the .hex file ...
Why don't you debug the code and see where it hangs?
I can run the simulation debug, but in this way the system works normally. I can't run JTAG debug because I do not have JTAG link.
If nothing else, perhaps all this just goes to show that you should get a JTAG link!
Without ULINK (JTAG debugger) you will not be able to find out easily why your application hangs, especially if in simulator it works.