Hi fellow hobby freeks.
I need to make an LCD cube with 100x100x100 LCDS' and I know that a KEIL CX51 is the best processor for the project.
BUT how can I wire the LCDS' to the processor.
I think I would go for a full 3D cube of 100MHz 1-clockers. 100x100x100 fast 1-clockers should have quite a lot of computing power to play with - a peak performance of 10^14 instructions/s can't be ignored.
And 1 million processors sending out parts of the video data on the individual serial ports should allow for a quite high total resolution. 19200 baud would be 19.2gbit/s total output capacity - and everyone should know that the 8051 can run at way more than 19200 baud. One full HD image at 24fps with 12-bit/color channel would need about 2.1gbit/s of data. At 19200 baud, the total output capacity would be enough to show one Full HD image on each side of the cube and still have plenty for streaming DTS HD Master Audio.
Please posts photos.