Hi, When I flash my STR9, I receive the message box: " Flash Timeout. Reset the Target and try it again " and after this message, another one: " Flash Donwload failed - ARM9E "
I tried to flash my STR9 with the same project on 3 different computers, for two it is working but for one of them I get the messages written above.
Any suggestions ? In advance thank you !
* Wrong flash algorithm selected. >> No
* Bad PLL settings. See STR9 knowledge base to resolve this. >> maybe but why does it work sometimes and sometimes not ? if the pll settings are wrong, the device shouldn't work every times? no ?
* Broken hardware...? >> We tried with another MCBSTR9 and the problem was the same.
Thanks for your answer
Hi,
I too get this problem often. But i use the same PC, same debugger and same project. Sometimes, it works with no difference in settings. i just remove power for my target, debugger and then restart again, it works.(sometimes). May be, it has some order to be followed!
vivek
Thanks for you answer. That fears me.
We found something interesting: We plugged the ULINK2 directly to a USB plug of our computer (previously, we plugged it to a USB plug of a USB switch) and now, it's working...
So, try another plug of your computer ;)