hi, I am trying to use the logic analyzer to capture the output pin on my MCBSTM32 board. I have try to add "GPIOB" into Current Logic Analyzer Signals under Setup Logic Analyzer Menu, but couldn't seems to do that successfully. May i know whats the right way to add and monitor the signal? This pin is connected to an IR Emitter and the 38Khz carrier frequency toggle by a Timer ISR.
regards Thanks for any input. clgo
I'm quite sure that the ports are called PORTA, PORTB, ... in the simulator.
Where did you get the name GPIOB from?
Have you looked at keils documentation about simulated peripherials for your specific processor? That information also includes the names of the virtual registers you need to use.