Sir,
I am New to the USB side.I want to implement the USB which is on-chip in LCP2378 controller.
Pls send some info abt USB implementaion
What information do you require that isn't already in the documentation, examples, etc, provided by NXP?
See: http://www.keil.com/forum/docs/thread13843.asp
Yes, USB info is mentioned in the Document.But sir i am not understaning abt End point registers and Endpoint buffer.
My Question is What is endpoint?In my project i have to use DMA type transfer.
Pls Give some guide lines where i have to start?
Controller:LPC2378
So why didn't you make that clear in your original post?
The more care you take in making your question explicit, clear and complete, the more likely you are to get good answers - and sooner!
There are lots of general USB references; eg,
http://www.keil.com/usb/
http://www.usb.org/developers
http://www.lvr.com/usb.htm
Thank you,sir for giving site names .Its really helping me.