This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ULINK2 + uPSD = no Debug ??

Configuration:

ULINK2 internal jumper set for 3.3v

target: uPSD3454

No problem with downloading an image to the chip via the ULINK2, but can't stop on breakpoints. After entering the Debugger, it's possible to single step, but not able to stop on breakpoints. As soon as RUN is selected, the only way to reset the board is to disconnect the USB connection of the ULINK2. When HALT is selected from the UI, it just stares back at me with no functionality.

Has anyone had a similar experience?

0