• State Not Answered
  • Locked Locked
  • Replies 1 reply
  • Subscribers 20 subscribers
  • Views 760 views
  • Users 0 members are here
Options
How was your experience today?
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

MAP command

Anshul Data

Hi,

I am using Ashling EPKSC Emulator with uvision. I am trying to run MAP command {it allows memory map to be defined} on it but I am getting error "Command not supported in target mode".

In fact dscope manual says that when MAP command is given without any parameters it shows current memory map but I am getting same error when I type just MAP. I think I need to do some setting change. Any idea what I am missing?

Thanks

Regards,
Anshul

0