Keil forum "could not stop ARM device"

State Not Answered
Locked Locked
Replies 8 replies
Subscribers 21 subscribers
Views 1520 views
Users 0 members are here

2025 survey

We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.

Options

How was your experience today?

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

"could not stop ARM device"

Michael Economides over 16 years ago

uVision 3... I try to stop the debugger to see why my application is crashing. But then I get "Could not stop ARM device! Please check the JTAG cable." I then have to cycle power to be able to run my application again.

Any idea what could be causing this? It's hard to debug my software when the debugger does this.

Thanks,

Mike

Parents

0 while (); over 16 years ago in reply to Michael Economides

Hi Mike,

can you check if you experience the same problems with Blinky example from MDK?
Cancel
Vote up 0 Vote down

Cancel

Reply

0 while (); over 16 years ago in reply to Michael Economides

Hi Mike,

can you check if you experience the same problems with Blinky example from MDK?
Cancel
Vote up 0 Vote down

Cancel

Children

No data