Hi all, I'm beginning a project using keil uVision3 on a TI CC2510 chip. I don't want to buy the developer board from TI. What cheap and well functioning products should I use that will enable me to program the MCU's flash and debug it on target using uVision3 ?
Any help and advice will be greatly appreciated.
TI do also have a lot of low-cost develeopment tools; eg, their eZ430-RF2480...
Boy, I need to read better. Because this was on a Keil forum, I assumed it was a Keil product. Duh!. I should know better. Sorry about the mis-information. Bradford