Hi all, I'm beginning a project using keil uVision3 on a TI CC2510 chip. I don't want to buy the developer board from TI. What cheap and well functioning products should I use that will enable me to program the MCU's flash and debug it on target using uVision3 ?
Any help and advice will be greatly appreciated.
... but TI ($650)
what you 'can' do is to make your own board (with RF that's going to be fun) and use Keil (which it seems - based on your posts - the uni has).
Erik
TI do also have a lot of low-cost develeopment tools; eg, their eZ430-RF2480...