This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Stop data uploading

Hello,

i am using uVision and USpear to program and debug an ADUC832 (8051 architecture).

But if i step throug the application (debugging) the steps takes a lot of time, i think the USpear loads all Data (XRAM, IDATA, DATA etc) from the uController and so it takes a lot of time...

Do you know how i can tell uVision that i don't want to upload everything??

Thank you very much
Greets
Benny