Gang:
I've been reading through all of the NXP LPC2919 (ARM9) docs trying to figure out how to set up and use any one of the 24 PWM channels on the device. I'm so baffled, I don't even know where to start.
I've got serial ports, timers, GPIO, and CAN working just fine. Pretty straightforward stuff there (okay... the VIC is a bit funky...but understandable after a few reads), but the PWM stuff is beyond me!
So...I'm wondering if anyone has a small piece of code that shows how it all goes together.
Normally, I wouldn't post a request as lame as this one, but I'm lost!
Any help appreciated,
-=Rich=-