This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Compiling LPC2368 using GNU in Keil uVision3

Hi,

I am working on MCB2300 Board (LPC2368 chip) and using newest Keil uVision3.
I would like to use GNU to compile. But right now, I can't find the startup.s and link file for the LPC2368 chip.

Please give me a hand

Thanks

Parents

0 Keil Software Support Intl. over 16 years ago in reply to Andy Neil

Support is mis-leading. What it really means is that you may run the Code Sourcery GNU implementation in the uVision IDE.

We cannot provide GNU with code examples as we do for our commercial RealView Compiler.
Cancel
Up 0 Down

Cancel

Reply

0 Keil Software Support Intl. over 16 years ago in reply to Andy Neil

Support is mis-leading. What it really means is that you may run the Code Sourcery GNU implementation in the uVision IDE.

We cannot provide GNU with code examples as we do for our commercial RealView Compiler.
Cancel
Up 0 Down

Cancel

Children

No data