We are running a survey to help us improve the experience for all of our members. If you see the survey appear, please take the time to tell us about your experience if you can.
Hi: I am new at programming the ARM device (LPC2194) and the Keil tools. I am writing small programs to learn with but am having no success at getting them to run because I don't have a license from Segger to run the Flash routine and can't use Flash Magic because the board I am using (borrowed from a friend) is not a development board and has a resistor on P0.14 to Vcc to block the bootloader. Can someone give me some advice on how to setup the startup code to run in RAM. Also, do I have to calculate the Program Signature?
Any and all help will be gratefully accepted. Thanks in advance for responding.
See your D:\Keil\ARM\Boards\Keil\MCB2100\Blinky.
It has 2 targets: RAM and Flash. Pay attention to ram.ini (debug tab in target options menu). This file loads your image once you start to debug on the target.