This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CC1010 - Changing the frequency runtime

Hi Guys,

I am trying to find out if it is possible to change the receiver frequency [for CC1010] during runtime.
For example, i start at 433 MHz, then, after a few seconds I will change the frequency to 434 MHz and so on...
I have read all the documents that I can get my hands on but none of it specifically says anything about this.
And, in the code documentation, it says that the frequency is changed using RF Studio. Does it mean that I cannot do it at all during runtime[I do not want to use RF studio in anyway to do this]

I am quite new to this. So any help would be highly appreciated.

Thanks,
Vinod

0